Western PRO-FLO 2 Bedienungshandbuch Seite 1

Lit. No. 13648January 1, 2002PRO-FLO™TAILGATE SPREADEROwner’s Manual CAUTIONRead this manual before installing or operatingthe spreader.This manual s

January 1, 2002 6 Lit. No. 13648/9511MOUNTING THE SPREADERIn-Bed Mount1. Remove the tailgate from the vehicle.2. Place the mount assembly into the bed

Lit. No. 13648/9511 7 January 1, 20029. Connect the spreader wiring harness to the vehiclewiring harness.Under-Frame Mount1. Install the secondary fra

January 1, 2002 8 Lit. No. 13648/9511MOUNTING THE SPREADERNOTE: Grease all electrical connections withdielectric grease.7. Verify proper stoplight and

Lit. No. 13648/9511 9 January 1, 2002OPERATING THE SPREADERDriving and Spreading on Snow and Ice CAUTIONDrinking and then driving or spreading is very

January 1, 2002 10 Lit. No. 13648/9511OPERATING THE SPREADERAdjusting the Gates and the DeflectorSpread pattern, pattern width, and the amount ofmater

Lit. No. 13648/9511 11 January 1, 2002STARTBLASTONOFFSPINNERMIN MAX12345679SPEED8Power SwitchUsed to start andstop the spinnerOFF position operatesas

January 1, 2002 12 Lit. No. 13648/9511BLASTONOFFSPINNEROn/Off Control SwitchUsed to start and stopthe spinner. OFF positionoperates as emergencystop

Lit. No. 13648/9511 13 January 1, 2002NOTE: Empty the hopper before removing thespreader.REMOVING THE SPREADERIn-Bed Mount1. Disconnect the spreader w

January 1, 2002 14 Lit. No. 13648/9511REMOVING THE SPREADERUnder-Frame MountNOTE: Empty the hopper before removing thespreader.NOTE: Grease the electr

Lit. No. 13648/9511 15 January 1, 2002RECEIVER HITCHSafety CAUTIONNever exceed the gross trailer weight or tongueweight of this equipment. Never exce

January 1, 2002 16 Lit. No. 13648/9511RECEIVER HITCHSway ControlsSway controls can lessen the effects of suddenmaneuvers, wind gusts, and buffeting ca

Lit. No. 13648/9511 17 January 1, 2002MAINTENANCETo keep your spreader running smoothly, observe thefollowing recommendations:• Lubricate grease fitti

January 1, 2002 18 Lit. No. 13648/9511Cab ControlWhite ConnectorRed Connector8 Ga. Red8 Ga. RedTwo-Way MoldedConnector6 Amp Fuse14 Ga. RedTo Vehicle I

Lit. No. 13648/9511 19 January 1, 2002Cab ControlWhite ConnectorRed Connector8 Ga. Red8 Ga. RedTwo Way MoldedConnector10 Amp Fuse14 Ga. RedTo Vehicle

January 1, 2002 20 Lit. No. 13648/9511TROUBLESHOOTING GUIDEVARIABLE SPEED (PWM) CONTROL TROUBLE SHOOTING GUIDECONDITIONLeft (Red)LightRight (Green)Lig

Lit. No. 13648/9511 21 January 1, 2002

January 1, 2002 22 Lit. No. 13648/9511

Lit. No. 13648/9511 23 January 1, 2002

Copyright© 2002 Douglas Dynamics, L.L.C. All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed,mecha

January 1, 2002 iii Lit. No. 13648/9511TABLE OF CONTENTSPREFACE...

Lit. No. 13648/9511 1 January 1, 2002PREFACEThis manual has been prepared to acquaint you withthe safety information, operation and maintenance ofyour

January 1, 2002 2 Lit. No. 13648/9511SAFETY INFORMATIONBefore You Begin• Park the vehicle on a level surface, place shiftlever in PARK or NEUTRAL and

Lit. No. 13648/9511 3 January 1, 2002SAFETY INFORMATIONNOTE: Maintain proper belt tension for correctbelt functioning.NOTE: Lubricate grease fittings

January 1, 2002 4 Lit. No. 13648/9511SAFETY INFORMATIONUnder-Frame Mount Assembly LabelsThe diagram below indicates the location of the safetyand iden

Lit. No. 13648/9511 5 January 1, 2002950 lb.371 lb.3.9 ft.³Sand = 95 lb./ft³Salt = 40 lb./ft³10 ft.³400 lb.3.9 ft.³156 lb.385 lb. Spreader385 lb. Spre